Polaris 2003 MSX Uživatelský manuál Strana 52
- Strana / 114
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
50
OPERATION
Engine Break-in Procedure
1. Make sure the drain plugs are installed securely
and launch the watercraft.
2. Push the rear of the watercraft up and down several
times in the water.
3. Check the throttle for free operation.
4. Remove the seat and ventilate the engine
compartment.
5. Secure the seat, board the craft and start the
engine. Allow it to warm up for about a minute
before departing.
6. Operate the watercraft at the lowest possible speed
for the first five minutes of operation.
7. Gradually open the throttle to half speed (half
throttle).
8. Vary throttle speeds up to 3/4 speed during the
break-in period (first full tank of fuel).
CAUTION
If the engine is operated while the watercraft is in
very shallow water, sand, weeds and debris may
be sucked into the jet intake and could cause
damage to the impeller or injury to bystanders.
Ingesting sand into the cooling system will cause
the engine to overheat, which could lead to engine
damage.
Whenever starting the engine, always be sure the
watercraft is in water at least two feet (60 cm)
deep.
- Owner's Manual 1
- The engine exhaust from this 2
- Check it out 3
- TABLE OF CONTENTS 6
- YOUR RESPONSIBILITIES 7
- IDENTIFICATION NUMBERS 9
- Signal Words and Symbols 10
- Safety Decals 11
- Informational Decals 15
- Operator Safety 16
- FEATURES AND CONTROLS 26
- EMISSIONS 38
- OPERATION 40
- MAINTENANCE AND LUBRICATION 76
- ENGINE TROUBLESHOOTING 100
- POLARIS PRODUCTS 103
- SPECIFICATIONS 104
- WARRANTY 106
- POLARIS WATERCRAFT ENGINES 109
- Pantone 307 114
- BAG, AT ALL TIMES 114
Související produkty a manuály pro Motor Polaris 2003 MSX
(71 stránky)Devair manuals
The list of Devair product deivces contains 6 user manuals and guides for 4 models in 2 type of devices
Komentáře k této Příručce